SAE J1730_199610
- ABS Excitor Ring Location Standardization
- standard by SAE International, 10/01/1996
- Publisher: SAE
$37.00$74.00
This SAE Recommended Practice is to establish the Antilock Brake System (ABS) sensor interface and envelope dimensions for standardizing the location of the Antilock Brake System (ABS) rings mounted on the inner end of the hub on the following axle designations: a. FF front; b. FL front; c. L powered rear; d. R powered rear; e. U powered rear; f. W powered rear; g. N trailer and h. P trailer.
This document provides standardized wheel end Antilock Brake System (ABS) sensor interface dimensions for spoke wheels and hubs intended for normal highway use on trucks, buses, truck trailers, and multipurpose passenger vehicles.
Related Products
SAE AMS7258B
Rings, Sealing, Butadiene-Acrylonitrile (NBR) Rubber Fuel Resistant, Low Shrinkage 65 - 75..
$37.00 $74.00
SAE AMS4205C
Aluminum Alloy, Plate, 6.2Zn - 1.8Cu - 2.4Mg - 0.13Zr (7010-T73651) or (7010-T7451), Solution Heat T..
$37.00 $74.00
SAE AS 21438B
Bearing, Roller, Needle, Single Row, Heavy Duty, Track Roller, Sealed, Type V Antifriction, Inch..
$37.00 $74.00
SAE AMS6274R
Steel, Bars, Forgings, and Tubing 0.50Cr - 0.55Ni - 0.20Mo (0.18 - 0.23C) (SAE 8620)..
$37.00 $74.00