ASTM F2159-09
- Standard Specification for Plastic Insert Fittings Utilizing a Copper Crimp Ring for SDR9 Cross-linked Polyethylene (PEX) Tubing
- standard by ASTM International, 12/01/2009
- Publisher: ASTM
$26.00$52.80
1.1 This specification establishes requirements for sulfone plastic insert fittings and copper crimp rings for four sizes (³/8, 1/2, and ¾ and 1) of cross-linked polyethylene (PEX) plastic tubing. These fittings are intended for use in 100 psi (690 kPa) cold- and hot-water distribution systems operating at temperatures up to and including 180°F (82°C). Included are the requirements for material, molded part properties, performance, workmanship, dimensions, and markings to be used on the fittings and rings.
1.2 Units - The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 The following is an index of the appendix in this specification:
GO/NO-GO Crimp Gauges | Appendix X1 |
1.4 The following precautionary caveat pertains only to the test method portions, Sections 11 and 12, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.
Related Products
ASTM D5009-02
Standard Test Method for Evaluating and Comparing Transfer Efficiency of Spray Applied Coatings Unde..
$23.00 $46.80
ASTM E2033-99
Standard Practice for Computed Radiology (Photostimulable Luminescence Method)..
$26.00 $52.80
ASTM E1282-98(2004)
Standard Guide for Specifying the Chemical Compositions and Selecting Sampling Practices and Quantit..
$23.00 $46.80