ASTM D4435-08
- Standard Test Method for Rock Bolt Anchor Pull Test
- standard by ASTM International, 07/01/2008
- Publisher: ASTM
$26.00$52.80
1.1 The objective of this test method is to measure the working and ultimate capacities of a rock bolt anchor. This method does not measure the entire roof support system. This method also does not include tests for pretensioned bolts or mine roof support system evaluation.
1.2 This test method is applicable to mechanical, cement grout, resin, (epoxy, polyester, and the like), or other similar anchor systems.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D 6026.
1.4.1 The method used to specify how data are collected, calculated, or recorded in this standard is not directly related to the accuracy to which the data can be applied in design or other uses, or both. How one applies the results obtained using this standard is beyond its scope.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Related Products
ASTM F449-97
Standard Practice for Subsurface Installation of Corrugated Polyethylene Pipe for Agricultural Drain..
$26.00 $52.80
ASTM D5775-95(2009)e1
Standard Test Method for Rubber—Determination of Bound Styrene in Styrene Butadiene Rubb..
$23.00 $46.80
ASTM C1438-11a
Standard Specification for Latex and Powder Polymer Modifiers in Hydraulic Cement Concrete and Morta..
$23.00 $46.80
ASTM D3511-05
Standard Test Method for Pilling Resistance and Other Related Surface Changes of Textile Fabrics: Br..
$26.00 $52.80