ASTM D3917-12
- Standard Specification for Dimensional Tolerance of Thermosetting Glass-Reinforced Plastic Pultruded Shapes
- standard by ASTM International, 04/01/2012
- Publisher: ASTM
$23.00$46.80
1.1 This specification defines tolerances applicable to standard rods, bars, and shapes pultruded from thermosetting glass-reinforced plastics.
1.2 These dimensional tolerances apply to all shapes specified as "standard" by the pultrusion industry.
1.3 Custom shapes and products designed for special applications may carry specific tolerances that vary from the standard.
1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.5 The following safety hazards caveat pertains only to the test methods portion, Section 4, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1 - There is no known ISO equivalent to this standard.
Related Products
ASTM D6693-03
Standard Test Method for Determining Tensile Properties of Nonreinforced Polyethylene and Nonreinfor..
$23.00 $46.80
ASTM D804-12
Standard Terminology Relating to Pine Chemicals, Including Tall Oil and Related Products ..
$20.00 $39.00
ASTM D2375-85(1999)
Standard Test Method for Manganese in Paint Driers by EDTA Method..
$23.00 $46.80