ASTM D2063/D2063M-10
- Standard Test Methods for Measurement of Torque Retention for Packages with Continuous Thread Closures Using Non-Automated (Manual) Torque Testing Equipment
- standard by ASTM International, 04/01/2010
- Publisher: ASTM
$23.00$46.80
1.1 These test methods evaluate the torque retention of continuous thread closures on containers, with matching finishes, for predetermined environmental conditions over time.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
Note 1 - The SI unit system is the recommended system.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Related Products
ASTM E887-88(2004)
Standard Test Method for Silica in Refuse-Derived Fuel (RDF) and RDF Ash..
$23.00 $46.80
ASTM D5980-96e1
Standard Guide for Selection and Documentation of Existing Wells for Use in Environmental Site Chara..
$26.00 $52.80
ASTM E499-95(2006)
Standard Test Methods for Leaks Using the Mass Spectrometer Leak Detector in the Detector Probe Mode..
$26.00 $52.80
ASTM C127-88(2001)
Standard Test Method for Density, Relative Density (Specific Gravity), and Absorption of Coarse Aggr..
$26.00 $52.80