ASTM A1011/A1011M-12
- Standard Specification for Steel, Sheet and Strip, Hot-Rolled, Carbon, Structural, High-Strength Low-Alloy, High-Strength Low-Alloy with Improved Formability, and Ultra-High Strength
- standard by ASTM International, 03/01/2012
- Publisher: ASTM
$26.00$52.80
1.1 This specification covers hot-rolled, carbon, structural, high-strength low-alloy, high-strength low-alloy with improved formability, and ultra-high strength steel sheet and strip, in coils and cut lengths.
1.2 Hot rolled steel sheet and strip is available in the designations as listed in 4.1.
1.3 This specification is not applicable to the steel covered by Specification A635/A635M.
1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
Related Products
ASTM F468-06
Standard Specification for Nonferrous Bolts, Hex Cap Screws, and Studs for General Use..
$30.00 $60.00
ASTM D4801-95
Standard Specification for Polyethylene Sheeting in Thickness of 0.25 mm (0.010 in.) and Greater..
$23.00 $46.80
ASTM F2234-08
Standard Specification for Spill Resistant Fueling Systems for Portable Fuel Containers for Consumer..
$22.00 $44.00
ASTM D6928-08e1
Standard Test Method for Resistance of Coarse Aggregate to Degradation by Abrasion in the Micro-Deva..
$26.00 $52.80